| After-sales Service: | Whole Life After Sale Service |
|---|---|
| Warranty: | 2 Years |
| Tile Type: | Colored Steel |
| Customization: |
|---|
|
Shipping Cost:
Estimated freight per unit. |
about shipping cost and estimated delivery time. |
|---|
| Payment Method: |
|
|---|---|
| Initial Payment Full Payment |
| Currency: | US$ |
|---|
| Return&refunds: | You can apply for a refund up to 30 days after receipt of the products. |
|---|
Suppliers with verified business licenses
Audited Supplier 
| Suitable material | PPGI,Aluzinc ,GI |
| Material thickness | 0.3mm-0.6mm |
| Material width | 1200mm |
| Main motor | 5.5kw |
| Cutter motor | 4kw |
| Forming Stations | 16 staions / 16 stations |
1 |
Power Requirement |
Voltage | 380v/3ph/50hz |
| Main Motor power | 5.5kw | ||
| Cutter power | 4kw | ||
| 2 | Forming speed | 10-20m/min | |
| 3 | Forming stations | 14 row /21 row | |
| 4 | Forming shaft diameter | 75mm | |
| 5 | Chains | 1 inch | |
| 6 | Type of cutting | Roll formed and length-set cutting | |
| 7 | Control system | PLC Delta Brand | |
| 8 | Install dimension(depend on the final design) | 9.8m×1.5m×1.8m | |
| 9 | Total weight (Approx) | 7.5T | |
| Hydraulic Decoiler | Usage:It is used to support the steel coil and uncoil it in a turnable way. The steel coil is uncoiled automatically. Loading capacity:5T Inner diameter: 450-508mm |
| Guiding Device with Pre cutter | Adopt guiding bar and sliding wheels to control the width and position of the steel sheet. Easy to adjust the wheels to get the raw material feeding into the machine. Pre-cutter used to cut sheet before roll forming , saving material . |
| Roll Forming System | Material of rollers:45# steel,roller surfaces polishing, hard plating , The polished surface and the heat treatment towards the molds also can keep the molding plate surface smooth and not easy to be marked when it is being stamped. Using solid rollers and spacers to assemble the machine. |
| Cutting device | A. Adopts post cutting, the cutting blade material is Cr12 with quenched treatment, after cutting, there is no material wasted. B. Adopts pillar type for good rigidity. C. The cutting action is drove by the power from hydraulic station which guarantees the procession of the cutting and low noisy, long life. |
| Hydraulic System |
It is controlled by gear wheel oil pump. After filling the hydraulic oil into the hydraulic oil tank ,the pump drive the cutter machine to begin the cutting job. |
| PLC Control System | The target piece`s length is adjustable and digit of it can be adjusted. Computed mode has two modes: automatic and manual one. The system is easy to operate and use PLC:Delta |
| Run out table |
To receive the finished products. |
| No. | Item | Qty |
| 1 | Limited switch | 2 |
| 2 | Chains | 1 |
| 3 | Value | 1 |
| 4 | Relay | 1 |
| 5 | Chains Joint | 2 |
| 6 | Encoder wheels | 2 |
Suppliers with verified business licenses
Audited Supplier 
){kind=link}
){kind=link}